I assembled two 2-chip dialyzers using the thicker, 75-nm NPN membrane chips (10 mm long multichannel, 22 mm x 24 mm). The dialyzers were pumped full of IPA, to fill with fewer bubbles, then infused with PBS for at least…
Tag: counterflow system
Counter Flow Dialysis Device Design
Upper and lower gaskets used to make a counter flow device. The danger is that the enclosing pdms can easily flex into the membranes on the flat side of the chip. A hard plastic cover can be used to prevent…
Materials in contact with media in micropump
The pump’s data sheet (located here) describes the pumps materials as: polyphenylene sulphone (PPSU) polyimide (PI) nitrile butadiene rubber (NBR) It also says that the acceptable particle tolerance is < 50 μm. This is the info we will need to…
Counter Flow System Progress
Just wanted to post an update on the creation of a counter flow system using the pncSi chips from wafer 619 (the wafer with the etched trenches for the insertion of capillary tubing). Over the past few weeks Henry and…
